Lantronix 2100E manual Incoming Connection, Response, Active Startup

		7: Setup Mode: Channel Configuration
a) Incoming Connection
	Never Accept Incoming	Rejects all external connection attempts.
	Accept with active Modem	Accepts external connection requests only when Modem
	Control In	Control In input is asserted. Cannot be used with Modem Mode.
	Always Accept	Accepts any incoming connection when a connection is not
		already established. Default setting.
b) Response
	Character Response
		A single character is transmitted to the serial port when there is a
		change in connection state:
		C = connected, D = disconnected, N = host unreachable.
		Single character mode specifies the character response. The IP
		address of the host connecting to the unit displays when the unit
		is in verbose mode. This option is overridden when the Active
		Start Modem Mode or Active Start Host List is in effect.
		Default setting is Nothing (quiet).
c) Active Startup
	No Active Startup	Does not attempt to initiate a connection under any
		circumstance. Default setting.
	With Any Character	Attempts to connect when any character is received from the
		serial port.
	With active Modem Control	Attempts to connect when the Modem Control In input changes
	In	from not asserted to asserted.
	With a Specific Start	Attempts to connect when it receives a specific start character
	Character	from the serial port. The default start character is carriage return.
	Manual Connection	Attempts to connect when directed by a command string
		received from the serial port. The first character of the command
		string must be a C (ASCII 0x43), and the last character must be
		either a carriage return (ASCII 0x0D) or a line feed (0x0A). No
		blanks or space characters may be in the command string.
		Between the first and last command string characters must be a
		full or partial destination IP address and may be a destination
		port number.
		The IP address must be in standard decimal-dot notation and
		may be a partial address, representing the least significant 1, 2,
		or 3 bytes of the remote IP address. The period is required
		between each pair of IP address numbers.
		If present, the port number must follow the IP address, must be
		presented as a decimal number in the range 1-65535, and must
		be preceded by a forward slash (ASCII 0x2F). The slash
		separates the IP address and the port number. If you omit the
		port number from a command string, the internally stored remote
		port number starts a connection.
		If a partial IP address is presented in a command string, it is
		interpreted to be the least significant bytes of the IP address and

WiBox® 2100E Device Server User Guide 53