7: Setup Mode: Channel Configuration

 

 

 

 

 

 

 

Table 7-8. Modem Mode Commands

 

 

 

 

 

 

Modem Mode Command

Function

 

 

 

 

 

 

ATDTx.x.x.x,pppp or

Makes a connection to an IP address (x.x.x.x) and a remote port number

 

 

ATDTx.x.x.x/pppp or

(pppp).

 

 

ATDTx.x.x.x:pppp

 

 

 

 

 

 

 

ATDTx.x.x.x

Makes a connection to an IP address (x.x.x.x) and the remote port

 

 

number defined within the unit.

 

 

 

 

 

 

 

 

 

ATD0.0.0.0

Forces the unit into Monitor Mode if a remote IP address and port number

 

 

are defined within the unit.

 

 

 

 

 

 

 

 

 

ATD or ATDT

Forces the unit into Monitor Mode if a remote IP address and port number

 

 

are not defined within the unit.

 

 

 

 

 

 

 

 

 

ATDx.x.x.x

Makes a connection to an IP address (x.x.x.x) and the remote port

 

 

number defined within the unit.

 

 

 

 

 

 

 

 

 

ATH

Hangs up the connection (Entered as +++ATH).

 

 

 

 

 

 

 

Enables or disables connections from the network going to the serial port.

 

 

 

n=0 disables the ability to make a connection from the network to the

 

 

ATS0=n

serial port.

 

 

n=1-9 enables the ability to make a connection from the network to the

 

 

 

 

 

 

serial port.

 

 

 

n>1-9 is invalid.

 

 

 

 

 

 

 

Enables or disables character echo and responses.

 

 

ATEn

n=0 disables character echo and responses.

 

 

 

n=1 enables character echo and responses.

 

 

 

 

 

 

 

Enables numeric response or full verbose.

 

 

ATVn

n=0 enables numeric response.

 

 

 

n=1 enables full verbose.

 

 

 

 

 

Note: The unit recognizes these AT commands as single commands such as ATE0 or ATV1; it does not recognize compound commands such as ATE0V.

Send the Escape Sequence (+++) in Modem Mode

Send ‘+++’ in Modem Mode (Y) ? _

Disable or enable the WiBox 2100E’s ability to send the escape sequence. The default setting is Y (Yes) (send the escape sequence).

Show IP addr after 'RING'

Show IP addr after ‘RING’ <Y> ?

Disable or enable the WiBox 2100E's ability to show the IP address after RING in Modem Mode. The default is Y (Yes), to show the IP address.

WiBox® 2100E Device Server User Guide

58

Page 58
Image 58
Lantronix 2100E manual Send the Escape Sequence +++ in Modem Mode, Show IP addr after Ring, Modem Mode Command Function