Lexmark 1200 manual Jobs from the disk without printing them, Operation, To the ready state

Attendance messages (continued)

Message	Action
Print Jobs on Disk?	Jobs that were spooled to the optional hard disk before the printer was last turned
	off have not yet printed. Press Go to print the jobs. Press Return or Stop to delete
	the jobs from the disk without printing them.
Files Will be Lost. Go/Stop?	You have changed the Job Buffer Size setting from the operator panel, and the
	printer must reformat the hard disk to activate the change. If you press Go, all files
	currently stored on the disk will be deleted. Press Return or Stop to cancel this
	operation.
Invalid Font Data	The printer has detected an incompatibility between the font data and the
	firmware. You must download compatible font data to flash memory before the
	printer can return to the ready state.
Invalid Network x Code	The code in the specified network adapter has not been programmed or is invalid.
	You must download valid code to the network adapter before the printer can return
	to the ready state.
30 color Print Unit Missing	The specified print unit (Cyan, Magenta, Yellow, or Black) is not installed in the
	printer. Insert the print unit and close the top cover to clear the message.
33 Tray x Configuration Error	The printer has detected a tray with the rear paper guide in the wrong position.
	When loading A4 and letter size paper, make sure you place it in the tray with the
	long-edge of the sheet next to the front of the tray. Position the rear paper guide
	correctly for the paper size, then insert the tray in the printer.
35 Res Save Off	The printer lacks the memory needed to enable the Resource Save function. This
Deficient Memory	message usually indicates that too much memory is allocated for one or more of
	the printer link buffers.
	To disable Resource Save and continue printing, press Go.
	To enable Resource Save after you get this message:
	• Set the link buffer for each interface to Auto, then exit the menus to activate the
	link buffer changes. When the Ready message is displayed, enable Resource
	Save from the Setup Menu.
	• Or, install additional printer memory. See page 66 for more information.
37 Insufficient Collation Area	The printer memory (or optional hard disk, if installed) does not have the space
	necessary to collate the print job.
	• Press Go to print the portion of the job already stored and begin collating the
	rest of the job.
	• Cancel the print job. Press Menu> or <Menu. The Job Menu is displayed. Press
	Menu> or <Menu until Cancel Job appears on the second line. Press Select.

104 Chapter 7: Solving printer problems