Linear DVS-2400 ALARM, Use an, CONSOLE, With the, EXTERNAL, EXTERNAL, Mount the external siren, Mount the external speaker, Use a 12 volt, 1 amp maximum rated

EXTERNAL CONSOLE SPEAKER CONNECTION (OPTIONAL)

◆An external console speaker sounds system tones and alerts occupants with a loud siren during alarm.

◆With the VB-2 module installed, the Central Station can talk to the occupants through the external console speaker.

◆Use an 8-ohm, 10 watt minimum rated speaker. Do not use a horn/siren with a built-in siren driver.

◆Up to two 8-ohm speakers can be used with each Console.◆Up to 150 feet of 22 AWG wire can be used with each speaker. Mount the external speaker. Route the speaker wires from the external speaker to the Console. Open the Console top cover and locate the main terminal block. Route the speaker wires up through the wiring access hole. Remove the wire jumper from the EXT. SPKR & (-) terminals. Connect the speaker wires to the EXT. SPKR & (-) terminals.

✍NOTE: If connecting two external speakers,

EXTERNAL

CONSOLE

LINEAR SECURITY CONSOLE MODEL DVS-2400

		MAIN TERMINAL BLOCK
			AC
			AC
	ANNUNCIATOR	EXT. SPKR(S)	EXT. SPKR
	VOLUME	8 OHM/10 WATT	(-)
MAIN	CONTROL	2 SPKRS MAX.	H/A -
		NOTE: REMOVE
TERMINAL			H/A +
BLOCK	OPTIONAL	JUMPER FOR	RELAY N.O.
	VOICE MODULE	EXT. SPEAKERS	RELAY DRY
	MODEL: VB-2 OR VB-3

EXTERNAL

CONSOLE

SPEAKER

8 OHM, 10 WATT

MINIMUM

REMOVE

connect the second speaker in parallel, to the

same EXT. SPKR & (-) terminals as the first

speaker.

The system tone volume can be adjusted with the annunciator volume control.EXTERNAL ALARM SIREN CONNECTION (OPTIONAL)

◆An external siren alerts occupants and neighbors with a loud siren during alarm.

◆Use a 12 volt, 1 amp maximum rated weather-resistant horn speaker with a built-in siren driver. Do not use a plain speaker.

JUMPER

CONNECT SPEAKER LEADS TO EXT. SPKR & (-) TERMINALS

EXTERNAL

ALARM

✍NOTE: Connection of an electromechanical bell or motor bell is not recommended because of the radio interference generated when the bell is running.

Mount the external siren. Route the wires from the external siren to the Console. Open the Console top cover and locate the main terminal strip. Route the siren wires up through the wiring access hole. Connect the siren wires to the RELAY N.O. & (-) terminals.

✍NOTE: By removing the Console’s auxiliary fuse, the relay contacts will become isolated. Use the RELAY N.O. & RELAY DRY terminals to switch an externally powered load.

LINEAR SECURITY CONSOLE MODEL DVS-2400

		MAIN TERMINAL BLOCK
			AC
			AC
		EXTERNAL SIREN	EXT. SPKR
			(-)
		12 VDC 1 AMP
MAIN			H/A -
		MAXIMUM
TERMINAL			H/A +
BLOCK	OPTIONAL		RELAY N.O.
	VOICE MODULE		RELAY DRY
	MODEL: VB-2 OR VB-3

EXTERNAL

ALARM RELAY 12 VDC 1 AMP MAXIMUM

CONNECT SIREN LEADS TO (-) & RELAY N.O. TERMINALS

9