◆The factory setting for the Console disables the communicator. If the system is going to be a
◆If the system is going to be monitored by a Central Station, enable the communicator with this programming step.
1
0PROGRAMMING STEP #107
7PRS
HOME PROGRAM
0 FOR COMMUNICATOR OFF
1 FOR COMMUNICATOR ON
AWAY STORE PROGRAM
◆When the Model
◆The audio module can be programmed for listen only,
◆Refer to the
✍NOTE: The Model
7PRS
PROGRAMMING STEP #76
6MNO
HOME PROGRAM
0 FOR NO AUDIO MONITORING
1 FOR
2 FOR
3 FOR
AWAY STORE PROGRAM
◆Alternately, the audio module can be set for (1)
✍NOTE: Units programmed for
◆The Console can be programmed to allow its speaker to play audio produced by the
◆This selection can also be used when a remote speaker is connected to the Console.
◆The factory setting is to disable the Console’s speaker from playing voice module audio.
◆Alternately, the Console can be programmed to enable voice module audio.✍NOTE: Turning voice response OFF with this programming step will only effect the audio produced by the voice module. It will not stop the Console’s speaker from sounding local sirens and tones.
✍NOTE: A Model
7PRS
PROGRAMMING STEP #78
8TUV
HOME PROGRAM
0 FOR NO VOICE RESPONSE
1 FOR VOICE RESPONSE
AWAY STORE PROGRAM
◆The factory setting for the communicator is to allow remote connection to the Console with Linear’s
◆Alternately, the Console can be programmed to not answer incoming calls, thereby, not allowing remote access (locked).
1
0PROGRAMMING STEP #100
0
HOME PROGRAM
0 FOR UNLOCK
1 FOR LOCK
AWAY STORE PROGRAM
33