6. BASIC CONSOLE PROGRAMMING
◆In a new installation, when power is first applied the Console’s master user code is “1234”.
CREATE THE MASTER USER CODE✍NOTE: Local programming must be entered on the Console’s keypad, not on a wireless remote keypad.
Press [∗] (clears keypad if any other keys have been pressed). Place the Console in Test Mode (enter 1234 and press [TEST].❇A “gong” and four “beeps” will sound. Enter the Setup Mode from Test Mode, enter 1234 then press [TEST] again.❇A “gong” and five “beeps” will sound. You are now in Setup Mode. Enter 99 then press [HOME]. Enter any combination ofMASTER USER CODE
✍NOTE: The master user code can be used to enter Setup Mode. The restricted user codes cannot. To create restricted user codes, see the “Advanced Programming” section of this manual.
PROGRAM THE SENSORS INTO THE CONSOLE’S MEMORY◆Each wireless sensor that is going to be used with the Console must be programmed into the Console’s memory.
ENTERING | SETTING A | |
SETUP | NEW MASTER | |
MODE | USER CODE | |
START IN OFF | START IN SETUP | |
CLEARS |
| |
KEYPAD | PROGRAMMING | |
| ||
| STEP #99 | |
DEFAULT |
| |
MASTER | PROGRAM | |
USER |
| |
CODE |
| |
| NEW | |
1 GONG & | MASTER | |
4 BEEPS | USER | |
(TEST MODE) | CODE | |
DEFAULT | STORE | |
MASTER | ||
CODE | ||
USER | ||
| ||
CODE | HOLD FOR | |
| 3 SECONDS | |
| TO EXIT | |
1 GONG & | SETUP | |
| ||
5 BEEPS | DONE | |
(SETUP MODE) | ||
|
Enter the Setup Mode from Test Mode, enter the master user code then press [TEST] again.
❇A “gong” and five “beeps” will sound. You are now in Setup Mode.
❇The sensor status indicators will light for any sensors programmed into the Console.
Enter an unused sensor number from
Activate the sensor by sending a test or alarm signal (be sure the sensor’s battery is connected or that its battery protection strip is removed).
TEST
MASTER USER CODE
1 GONG &
5 BEEPSNEW SENSOR NUMBER❇A single “bing” tone will sound and the sensor status indicator for that sensor will stay lit.
Enter another sensor number or exit Setup Mode by holding the [OFF] key for three seconds.
DONE
12