✍NOTE: For the Automation Output to activate during an alarm, that function must be enabled with Programming Step 71 or 72.
◆If the Automation output is programmed to activate during an alarm, it can be programmed to flash or be steady.
6MNO
PROGRAMMING STEP #68
8TUV
HOME PROGRAM
0 FOR FLASHING OUTPUT ON ALARM
1 FOR STEADY OUTPUT ON ALARM
AWAY STORE PROGRAM
◆The factory setting causes the Console to sound a “bing” when the Automation Output is activated by pressing the [(A)] key, or when it’s triggered with a
6MNO
PROGRAMMING STEP #69
9WXY
HOME PROGRAM
0 FOR BING TONE OFF
1 FOR BING TONE ON
AWAY STORE PROGRAM
◆When arming with the portable remote control, the factory setting causes the Console to “chirp” once when armed, twice when disarmed, and three times when arming with sensors bypassed.
◆Alternately, these chirps can be silenced.✍NOTE: If these chirps are silenced, it is recommended to program the Automation Output to be active when the system is armed, so a light can be triggered displaying the arming status of the Console.
7PRS
PROGRAMMING STEP #70
0
HOME PROGRAM
0 FOR CHIRPS OFF
1 FOR CHIRPS ON
AWAY STORE PROGRAM
◆ The factory setting causes the Console’s |
Automation Output to activate when pressing |
the [(A)] key, or when it’s triggered with a |
◆ In addition, the Console can be programmed to |
flash the Automation Output during and after |
7PRS
1
HOME
PROGRAMMING STEP #71
PROGRAM
0 FOR STANDARD TRIGGER
1 FOR FLASHING DURING & AFTER ALARM
any alarms. |
◆ The output will continue to flash until the flashing |
status lights are cleared. |
AWAY
STORE PROGRAM
◆The factory setting causes the Console’s Automation Output to activate when pressing the [(A)] key, or when it’s triggered with a
◆In addition, the Console can be programmed to activate the Automation Output during alarms.
✍NOTE: The Automation Output can be programmed to flash or be steady during alarm, see Programming Step 68.
7PRS
PROGRAMMING STEP #72
2ABC
HOME PROGRAM
0 FOR STANDARD TRIGGER
1 FOR OUTPUT DURING ALARM
AWAY STORE PROGRAM
29