Linear DVS-2400 CALL ROUTING, REPORTING FORMAT, COMMUNICATOR REPORTING OPTIONS, Communicator Reporting Option Table

COMMUNICATOR REPORTING OPTIONS

REPORTING FORMAT

◆The factory setting causes the communicator to report using the 4 by 2 format. This format allows four-digit account numbers from 0000 to 9999 and provides two-digit alarm codes.

◆Alternately ADEMCO CONTACT ID can be chosen as a reporting format. This format allows 4-digit account numbers from 0000 to 9999 and provides verbose report descriptions with Ademco Contact ID compatible Central Stations.

0PROGRAMMING STEP #105

5JKL

PROGRAM

HOME

0 FOR 4 BY 2

1 FOR ADEMCO CONTACT ID

AWAY

STORE PROGRAM

CALL ROUTING

◆The factory setting for the communicator is to route all calls to the primary telephone number. If communication is unsuccessful after five attempts to the primary number, the secondary number will be dialed for an additional five attempts. If the secondary number cannot be reached, the communicator will “sleep” for five minutes before starting the call process over again. A total of five sleep cycles (50 call attempts) can occur before the communicator stops calling.

◆Alternately, the communicator can be programmed to report supervisory events (low batteries, radio trouble, etc.) to the supervisory telephone number instead of the primary or secondary telephone numbers.

✍CAUTION: If the page alert user code feature is going to be used, the supervisory number is reserved for the pager number. DO NOT SET THE CALL ROUTING OPTION TO “1”.

8TUV

6MNO

HOME

AWAY

PROGRAMMING STEP #86

PROGRAM

0 FOR ALL TO PRIMARY/SECONDARY 1 FOR ALARMS ONLY TO

PRIMARY/SECONDARY

STORE PROGRAM

◆To disable supervisory reports, set call routing option to “1” and remove the supervisory telephone number or in 4 by 2 set the report to 0.

✍NOTE: Do not program the primary and secondary telephone numbers the same. See the FCC Telephone Rules and Regulations on the rear cover of this manual.

COMMUNICATOR REPORTING OPTIONS

STEP #	PROGRAMMING			POSSIBLE	FACTORY	INSTALLATION
STEP #	FUNCTION			VALUES	VALUE	VALUE
	FUNCTION			VALUES	VALUE	VALUE

		0	= ALL CALLS TO PRIMARY OR SECONDARY NUMBER
86	CALL ROUTING	1	= ALL ALARM CALLS TO PRIMARY OR SECONDARY NUMBER AND		0
		ALL OTHERS TO SUPERVISORY NUMBER
88	ACCOUNT NUMBER	4 DIGITS			EMPTY
89	PRIMARY PHONE NUMBER	UP TO 20 DIGITS			EMPTY
90	SECONDARY PHONE NUMBER	UP TO 20 DIGITS			EMPTY
91	SUPERVISORY/ PAGER PHONE NUMBER	UP TO 20 DIGITS			EMPTY
		PRESSING THE (A) KEY INSERTS A 1-SECOND DELAY
	FOR ALL PHONE NUMBERS ⇒⇒⇒⇒	THE [FIRE] KEY INSERTS A 5-SECOND DELAY
	FOR ALL PHONE NUMBERS ⇒⇒⇒⇒	THE [CHIME] KEY INSERTS A “*”
		THE (A) KEY INSERTS A “#” IF IT IS THE LAST DIGIT OF THE PHONE
		NUMBER
105	REPORTING FORMAT	0	= 4 BY 2; 1 = ADEMCO		0
108	REPORT CONSOLE TROUBLE	0	= NO; 1	= YES	0
110	REPORT FORCE ARMING	0	= NO; 1	= YES	0
111	OPEN/CLOSE	0	= NO; 1	= YES; 2 = MASTER PAC ONLY	0
113	POINT ID REPORTING FOR 4 BY 2 FORMAT	0	= NO; 1	= YES	1

Communicator Reporting Option Table