AUTOMATION OUTPUT WHILE ARMED
◆The factory setting causes the Console’s Automation Output to activate when pressing the [(A)] key, or when it’s triggered with a
◆In addition, the Console can be programmed to activate the Automation Output when the system is armed.
7PRS
PROGRAMMING STEP #73
3DEF
HOME PROGRAM
0 FOR STANDARD TRIGGER
1 FOR OUTPUT WHEN ARMED
AWAY STORE PROGRAM
AUTOMATION OUTPUT DURING EXIT/ENTRY DELAYS
◆The factory setting causes the Console’s Automation Output to activate when pressing the [(A)] key, or when it’s triggered with a
◆In addition, the Console can be programmed to activate the Automation Output during the exit and Entry Delays.
7PRS
PROGRAMMING STEP #74
4GHI
HOME PROGRAM
0 FOR STANDARD TRIGGER
1 FOR OUTPUT DURING EXIT/ENTRY DELAYS
AWAY
STORE PROGRAM
AUTOMATION OUTPUT POLARITY
◆The factory setting causes the Console’s Automation Output to provide a current limited voltage source when activated.
◆Alternately, the Console can be programmed so the Automation Output provides a current limited voltage source when deactivated.
7PRS
PROGRAMMING STEP #75
5JKL
HOME PROGRAM
0 FOR VOLTAGE WHEN OFF
1 FOR VOLTAGE WHEN ON
AWAY STORE PROGRAM
REMOTE ACCESS PASSWORD
◆This is the password used to gain access to the Console when using the
◆The password must be
Log the remote access password in the box below.
REMOTE ACCESS PASSWORD
8TUV
PROGRAMMING STEP #87
7PRS
HOME PROGRAM
AWAY STORE PROGRAM
DURESS CODE
◆The duress code will disarm the system, without any special indications or sounds, but will send the programmed duress code to the Central Station.
◆The duress code should be two or more digits different than any user code.
Log the duress code in the box below.
DURESS CODE
9WXY
PROGRAMMING STEP #92
2ABC
HOME PROGRAM
AWAY STORE PROGRAM
MASTER USER CODE
◆The master user code is 1234 when power is first applied to the Console.
◆The master user code can be changed through programming to any
✍NOTE: For maximum security, a
9WXY
PROGRAMMING STEP #99
9WXY
HOME PROGRAM
AWAY STORE PROGRAM
Log the master user code in the box below.
MASTER USER CODE
30