Configuring IP Routing (Layer 3)

There is an implied implicit permit all at the end of the list. Also, you can only have one list active at a time.

Creating Standard Access Rules

To create standard access rules:

1.In the IP Configuration section of the Web Agent window, click Access Lists. The IP Access List dialog box opens.

Note: The IP Access List dialog box displays all standard and extended access rules that have been created. If no rules have been created, the following statement displays: No IP Access Rules are currently configured.

2.Click Create Standard. Valid numeric values are 1-99.

3.Use Table 7-4 to configure your IP access rules to either filter or prioritize traffic:

 

Table 7-4.IP Access List Setup Parameters

 

 

 

Parameter

 

Allows you to specify...

 

 

 

Access List Name

 

The alphanumeric name assigned to the newly-created access

 

 

list.

 

 

 

Access Rule Index

 

The sequence number for each new rule you create. Note that

 

 

rules may override each other, so review your current

 

 

configuration prior to creating new rules for an access list.

 

 

 

Access Type

 

The method of handling incoming datagrams based on the IP

 

 

access type. Priority levels include:

 

 

• Deny/Filter - Allows you to filter out traffic based on the

 

 

specified configuration.

 

 

• Permit/Fwd pri8 (high) to pri1 (low) - Allows you to

 

 

prioritize traffic based on the specified configuration.

 

 

• Permit/Fwd with no change in priority - Allows you to

 

 

forward traffic with no change in priority.

 

 

 

Source Subnet

 

• Source Address - The IP address of a subnet that is denied

 

 

or granted access to the switch.

•Source Address Wildcard - A range of IP addresses that are denied or granted access to the switch. Place the number one (1) in the bit positions you want to ignore.

4.Click CREATE to save your changes, or CANCEL to restore previous settings.

Cajun P550/P220 Switch Operation Guide

7-9