Configuring the OSPF Routing Protocol (Layer 3)

2.Select the OSPF area to be removed.

3.Click DELETE. The OSPF area is removed.

Modifying OSPF Areas

To modify an OSPF area:

1.In the OSFP Configuration section of the Web Agent window, click Areas. The OSPF Areas dialog box opens.

2.Select the OSPF area to be modified.

3.Use Table 9-2 to modify your configuration.

4.Click APPLY to save your changes, or CANCEL to restore previous settings.

Modifying OSPF Interfaces

To modify an OSPF interface:

1.In the OSPF Configuration section of the Web Agent window, click Interfaces. The OSPF Interfaces dialog box opens.

Note: If OSPF is not enabled for your existing IP interfaces (VLANs) you must first enable OSPF before you can modify OSPF interfaces. Refer to “Configuring IP Interfaces” in Chapter 7 for more information on how to enable OSPF on IP interfaces.

2.Use Table 9-3 to determine how to modify your OSPF interfaces:

 

Table 9-3.OSPF Interface Parameters

 

 

Parameter

Definition

 

 

Select

Select the OSPF interface to be modified.

 

 

Interface

Displays IP interface (VLAN) that has OSPF enabled.

 

Note: This is a read-only field.

 

 

IP Address

Displays IP address associated with the OSPF interface.

 

Note: This is a read-only field.

 

 

Area

Enter the area ID configured for this interface.

 

 

DR Priority

Enter the decimal value for this interface for DR priority

 

functionality.

 

 

Transit Delay

Enter the estimated number of seconds it takes to transmit a link

 

state update packet over this interface.

 

 

9-4

Cajun P550/P220 Switch Operation Guide