Downloading New Operational Code to the Switch (Layer 2 & Layer 3)
4.From the TFTP Target Section
For example, select APP2 to download the new version to APP2 on the switch. If version 3.0 or 3.1 is installed in APP1, download version 4.0 to APP2.
5.Click Update in Perform Update Now.
6.Optional: Click Status in Get Status of Most Recent Update to ensure that the new image downloaded properly.
To download the version 4.0 software image to an APP location on the switch through the command line on version 3.0 or 3.1:
1.Recommended: Find the location where you want to save the image by entering the following command at the system prompt:
fep get
This command reads and displays information about the content stored in locations, such as APP1 and APP2, on the switch. If version 3.0 or 3.1 is installed in APP1, install version 4.0 in APP2.
2.Download the embedded software to the specified APP location by entering the following command at the system prompt:
download <APPname> <IP address> <file name>
where
❒<APPname> is the location in flash memory on the switch where you will download the new image.
❒<IP address> is the IP address of the server from which you download the new image
❒<file name> is the name of the file that contains the new image. Enter one of the following file names:
•
•
•
Cajun P550/P220 Switch Operation Guide |