Configuring the Cajun P550 Switch (Layer 2 & Layer 3)

14.Click Finish. The wizard closes and the newly configured connection displays in your Dial-Up networking program group.

15.Right-mouse click on your new connection and select Properties. The Properties dialog box opens.

16.Click the Server Types tab and de-selectall advanced options except TCP/IP.

17.Click TCP/IP Settings. The TCP/IP settings dialog box opens.

18.Click Specify an IP Address and enter the IP address of the serial port interface.

19.Click Server assigned name server addresses.

20.De-selectUse IP header compression and Use default gateway on remote network.

21.Click OK to close the TCP/IP dialog box.

22.Click OK to close the new connections properties dialog box.

Using Dial-Up Networking with a PPP Serial Port Console

To use TCP/IP applications (Telnet, HTTP, and SNMP) over your PPP serial port interface:

1.From My Computer, double-click Dial-Up Networking. The Dial-Up Networking program group opens.

2.Double-click on the PPP modem previously created. The Connect To dialog box opens.

3.Enter your password and click Connect. A Pre-Dial Terminal Screen opens. When the modem has successfully connected, a Post-Dial Terminal Screen opens.

4.In the Post-Dial Terminal screen, login using your CLI user name and password. It may be necessary to enter several carriage returns to view the Login prompt.

5.At the CLI prompt, go to configuration mode and enter set console transfer PPP. ASCII characters display below the CLI prompt. This is typical while the switch attempts to connect via PPP.

6.In the Post-Dial Terminal screen, click Continue (F7). PPP verification completes and the Connected To dialog box displays a message that the modem connection has been successfully established.

Cajun P550/P220 Switch Operation Guide

3-29