Configuring IP Routing (Layer 3)

To activate an access list:

1.In the IP Configuration section of the Web Agent window, click Access Control. The IP Access Control dialog box opens.

2.From the Enable pull-down menu, select Enable to filter inbound traffic.

3.From the IP Access List pull-down menu, select the name of the access list to be used for filtering when IP access control is enabled.

4.Click APPLY to save your changes, or CANCEL to restore previous settings.

Creating IP Static Routes

To create IP static routes:

1.In the IP Configuration section of the Web Agent window, click Static Routes. The IP Static Routes dialog box opens.

2.Use Table 7-6 to complete your static route configuration:

 

Table 7-6.IP Static Route Parameters

 

 

 

Parameter

 

Allows you to...

 

 

 

Network Address

 

Assign an IP network address for your IP static route.

 

 

 

Mask

 

Assign an IP subnet mask for your IP static route.

 

 

 

Next-Hop Address

 

Assign an IP address for the gateway associated with

 

 

the IP static route.

 

 

 

Next-Hop Interface

 

Select an interface that is associated with the IP static

 

 

route.

 

 

 

Cost

 

Specify the metric between this router and the

 

 

destination. Note that this overrides routing protocol

 

 

metrics.

 

 

 

Preference

 

Specify a low or high routing preference.

 

 

 

3.Click CREATE to save your changes, or CANCEL to restore previous settings.

Creating Static ARP Entries

To create a static ARP entry in your switch’s ARP cache:

1.In the IP Configuration section of the Web Agent window, click Static ARP. The IP Static ARP Entries dialog box opens.

2.Click CREATE. The Add IP Static ARP Entry dialog box opens.

7-14

Cajun P550/P220 Switch Operation Guide