Series 17 & Later
Figure
INPUT DEFINITIONS
DOOR LOCK SWITCH INPUT
When input is present, this is indication the washer door is locked. The machine control- ler will not command the spinner to spin faster than 50 rpm when the input is not present prior to spin.
END-OF-CYCLE SIGNAL INPUT
The
FABRIC SELECTION INPUTS
The Fabric Selection Inputs are energized through a user input switch on the control panel. The machine control reads these in- puts to determine which cycles should be run when the washer is started.
MAX EXTRACT INPUT
The Max Extract Input is energized through a user input switch on the control panel. When input is energized, the machine control will modify the final spin profile to the max ex- tract profile.
NOTE: If the user selects the Hand Washables fabric selection, all spins will follow the Max Extract profile regardless of whether the user selects the Max Extract option.
OUT-OF-BALANCE INPUT
The
System).
PRESSURE SWITCH INPUT
The input signal from the Pressure Switch serves two purposes. It supplies power for the water valves and provides an indication to the machine control as to whether the com- manded water level has been reached.
When the timer advances into a cycle se- quence that calls for water, power is supplied through the timer to either the wash or rinse level contacts on the pressure switch. When the water level in the tub is below the full level for that setting, the pressure switch circuit is closed, supplying power for the water valves to the machine control. When the water level switch is satisfied, the pressure switch circuit is opened and power for the water valves is no longer passed to the machine control. The
SECTION 1. GENERAL INFORMATION | ||
| © 1998 Maytag Corporation |
|
