screen test failed." In either case the screen will step to the next screen to check the membrane switches.
Service Cycle
User Interface
Test
Touch screen test passed.
Press the switches in any order.
home
favorites
back help start/pause off
start service
cycle
system check
cancel & exit service cycle
Press "start
service cycle" or start/pause button to begin service cycle
exit user
interface test
This test checks the membrane switches on the console pad.
The screen displays the status of the touch screen test that was just performed. The technician is then prompted to “Press the 5 keypads in any order." When each key is pressed, it will display in reverse image and remain that way. If all keys are sensed, the control will display “Membrane switch test passed." If any key(s) is not sensed within 10 seconds, the technician will be prompted to “Touch the key(s) that are not highlighted." If key(s) again are not sensed within 10 seconds, the control will display which key(s) failed.
The last step of the user interface test is to display the entire screen in reverse image for 2 seconds and then resume normal display mode. This is done as soon as the membrane switch test is complete. This is a visual test only.
Service Cycle
The service cycle can be run during a wash/spin cycle or can be used to initiate a particular cycle in the washer. To access this, select service cycle in the Service Mode.
To start a wash cycle in the Service Cycle: If the washer is not operating in a wash cycle, touch the icon start service cycle or start/pause key to begin the service cycle.
During a cycle:
While the washer is running, and service cycle is selected, the following screen will display and you can perform system checks of the various inputs and outputs of the washer by selecting system check. (See System Check)
Service Cycle
cancel cycle
system check
cancel & exit service cycle
16010486 | Section 2. Washer Controls Overview | |
| ||
Revised 02/01 | ©2001 Maytag Appliances Sales Company |
|
