©2001 Maytag Appliances Sales Company
2-12
16010486 (16008373-05)
Revised 02/01
Section 2. Washer Controls Overview
egnaRdeepSdeyalpsiD
mpr99-0)a )lautca(99-0
999-001)b
mpr
01/deepS
mpr+0001)c
tigidts1
AMPR0001<ro0001=>
BMPR0021<ro0011=>
CMPR0031<ro0021=>
snet-tigiddn2
MPR0201=2A:elpmaxE
MPR06116B
The following Quick Spin test steps are as
follows:
1) Lock the door.
2) Spin to 350 rpm and hold for 6 seconds.
3) Spin to 550 rpm and hold for 6 seconds.
4) Spin to 600 rpm and hold for 6 seconds.
5) Spin to 650 rpm and hold for 6 seconds.
6 Spin to 800 rpm and hold for 6 seconds.
7) Spin to 1000 rpm and hold for 6
seconds.
If the Spin key is pressed again during the
Quick Spin test, the current speed will be
held indefinitely. Pressing the Spin key again
will allow the quick test to proceed as listed
above.
When the washer is in the spin cycle
during the Service Mode, the speed will
be displayed as follows.
QUICK SERVICE CYCLE
Pressing the delicates key will start a
quick service cycle. This will be a quick
check of all systems.
The following steps will be followed.
1. Energize the cold and bleach. Fill to
Low level, then turn bleach and cold
off.
2. Energize the hot and fabric softener.
Fill to high level, then turn all valves off.
3. Tumble using 7/3 tumble pattern for 12
sec.
4. Lock the door.
5. Turn the drain on.
6. Spin to 800 RPM using default rates.
7. End spin and Coast down.
8. Unlock the door when the RPM is zero.
9. Display a PA on continuously for 10
seconds if no diagnostic codes were
logged during this test.
The up arrow if pressed will advance to
the next step. The right most dot should
be turned on as an indication of failure and
stay on until quick service cycle test has
reached the end. Any diagnostic code
logged during this test should result in
failure of the test, but should not necessar-
ily stop the test.
If any steps in the quick service cycle fail,
then a service mode is entered, and the
first diagnostic code that was logged
would be displayed.
While in quick service cycle, the pressing
of the hand wash will suspend the ma-
chine at this step until the Hand Wash key
is pressed again up to 30 minutes. All