Maytag 16010061 service manual Power LOSS/FAILURE, MAH7500A, Special Features, Advertising Mode

POWER LOSS/FAILURE

Power-up after a power-loss during a main wash cycle. The machine cycle will re- sume at the appropriate cycle step after the Start/Pause key has been pressed. The control recovers the saved information on power-up after a power loss. The recov- ery will be to the appropriate step in the cycle and within 3 minutes of the cycle step where the power loss occurred. The LCD display will be reset to the appropri- ate time left after the Start/Pause key has been pressed and not indicate a power failure at that point. The main wash cycle will resume immediately after the Start/ Pause key has been pressed.

When a power loss occurs during the final spin of a main wash cycle, the cycle will end, on the MAH5500B. The MAH7500A will finish the spin cycle.

Power-up after a power-loss during service mode, continuous mode, or advertising mode will cancel these modes.

These modes will not resume after the power-up until the user selections are pressed again.

If a power outage occurs during a cycle the washer will come back up in the paused state. When paused (either by a power outage or by the user), the washer will remember where it was. The machine will not automatically time-out and cancel a cycle while paused. The display will re- main on for 10 minutes after it is paused with no activity. After 10 minutes of no activity, the display will turn off, but the machine will remember where it was and the display will be turned back on with any user activity.

MAH5500B:

Information Saved:	Cause:
The beginning of the Last	Power-loss
cycle step performed.
Current User Interface	Power-loss
selections
Diagnostic codes, the total	When occurred
number of the diagnostics
since diagnostic number
has been cleared.
The number of cycles run	End of a
	completed
	wash cycle.

MAH7500A:

Continuously monitors and saves infor- mation to memory every minute or as cycle selection change.

SPECIAL FEATURES

The LCD and LED washers come with several new features not available with the earlier versions of the Neptune washers. By pressing a combination of keys, the washer can be placed into an Advertising Mode or into a Service Mode for the service technician.

ADVERTISING MODE

This mode will continuously display the LEDs on the keyboard or illuminate the LCD touch screen.

16010486 (16008373-05)	Section 2. Washer Controls Overview	2-9
Revised 02/01	©2001 Maytag Appliances Sales Company