Maytag 16010061 service manual Access Panel, Hinge Removal

CABINET ASSEMBLY w/REAR

ACCESS PANEL

Removal of the access panel gains access to the rear components of the washer (Figure 5-11).

Figure 5-9

3.Remove the door (See Door Assembly and

Hinge Removal).

4.Removal and replacement of the screws inthefollowingorder,asillustrated,isnec- essary to provide proper alignment of the parts. Failure to do so will hinder removal and replacement of the shroud onto the cabinet (Figure 5-10).

Figure 5-11

R E M O V A L

Remove the four hex-head screws surround- ing the access panel (Figure 5-12).

Figure 5-10

5.Place a soft cloth over the top of the con- crete weight. Carefully lift and stand the shroud assembly on top of the tub. The assembly can lean back against the top cover. The wire harness on the left side of the upper cabinet is long enough to do this. When replacing the shroud, be sure to tuck the harness inside the upper flange of the top cover to keep the wires from being pinched and damaged.

Spacer

Screws

Access Panel

Figure 5-12

16008373-01	SECTION 5. CABINET ASSEMBLY 5-5
	© 1998 Maytag Corporation