Mitsubishi Electronics WS-65869 manual Programming the Remote Control to Control Non-NetCommand

Part IV: Operation

Programming the Remote Control to Control Non-NetCommand™ A/V Products

To Program the Remote to Control Other Brands of Audio and Video Products:

(Figures 1-5)

1Move the slide switch at the top of the remote to the product you want to control.

2Press and hold the POWER button on the remote control.

3Enter the rst thr ee di gi t code li st ed for your equipment, and then release the POWER button on the remote control.

4Point the remote control at the equip- ment and press the POWER button. If the equipment responds, the remote control is properly programmed to oper- ate the equipment. If the equipment does not respond, repeat steps 2-4 with the next three digit code listed in step 3 for your equipment.

Figure 1. Programming the remote to control your cable box.

Figure 2. Programming the remote to control your satel- lite receiver.

Figure 3. Programming the remote to control your VCR.

Programming the Remote Control to Control Non-NetCommand™

	When the switch is set to TV, the PLAY,
	STOP, REW/REV, and FF/FWD buttons
If you cannot turn the cable box ON	will operate the VCR after the VCR codes
by pressing POWER, try pressing CHAN-	have been properly programmed into
NEL or the number buttons.	the remote control.

67