Mitsubishi Electronics WS-55859, WS-73909 External DTV Receiver with RGB Video Connections

Part II: Installation

Connecting an External DTV Receiver

External DTV Receiver with RGB

Video Connections

(Figure 1)

See Appendix B, page 73, for RGB video signal compatibility information.

For digital audio connections, see your DTV receiver and A/V receiver Owner’s Guides.

TV back panel
	3
	4	6
	5	7
White	8
Red	8

1Connect the outside antenna, cable, or satellite to ANT, or SATELLITE IN on the DTV receiver (see your DTV receiver’s owner’s guide for instructions, and cable compatibility).

2Connect the incoming terrestrial antenna, or cable (not satellite) to ANT-A on the TV back panel (a coaxial splitter, avail- able at most electronic supply stores, may be required to complete this instal-

lation).

Connect the RGB cables for the DTV receiver to the Input-DTV on the TV back panel. You may need to set the Input-DTV assignment to RGB using the “Change” option of the Edit Setup menu. Select this device to change and this assignment will be available.

Connecting an External

2

	3				AUDIO	8
		G			L	VCR
						CONTROL
	4	R			R	8	DIGITAL
				6
	RF		H				AUDIO OUT
	5	B		7
PHONE JACK	REMOTE		V			S-VIDEO

2	Incoming Antenna,
	or Cable.

	CAUTION
	RISK OF ELECTRICAL SHOCK
	DO NOT OPEN
CH 3
CH 4
IN	TELLITE IN

	3	DTV Receiver		TV Back Panel
		G (green)	=	Y/G
4		R (red)	=	Pr/R
5		B (blue)	=	Pb/B

If the DTV receiver has outputs for H and V sync, connect as listed below

DTV

Figure 1. Connecting the DTV receiver with RGB video connections.

(DO NOT connect if DTV receiver uses “Sync on Green”):

6	H (horizontal sync) =	H
7	V (vertical sync) =	V

Receiver

8

Connect the L (left) and R (right) audio cables from the DTV receiver to Input- DTV AUDIO on the TV back panel.

To utilize the bene ts of a dig tal A/V receiver, connect your DTV receiver’s digital audio out to a digital input on your digital A/V receiver.

23