Mitsubishi Electronics WS-55859 manual To Control Non-NetCommand, Programming the Remote Control

DVD position:

DVD

Cable box

Audio position:

A/V receiver

Mitsubishi CD player

TV position (when the remote has not been programmed to operate NetCommand™) :

TV

A/V receiver (volume and mute only)

Cable/DBS/DTV position:

Cable box

Satellite receiver

DTV receiver VCR position:

After entering the correct codes in each posi- tion of the remote control, use the slide switch to select which product will respond when an operational button is pressed. If the TV position has not been programmed to control NetCommand™ and you enter a code from the A/V Receiver chart while the slide switch is set to TV, the volume and mute functions change to match the A/V receiver. This is useful when using an A/V receiver with the TV all the time. In all other cases, only one of the below devices is allowed for each slide switch position.

Part IV: Operation

Programming the Remote Control to Control Non-NetCommand™ A/V Products

to Control Non-NetCommand™

Figure 4. Programming the remote to control your DVD/ LDP.

Programming the Remote Control

Figure 5. Programming the remote to control your A/V receiver.

VCR DVD LD Player

LD Player

VCR

Cable box

[If you have a Mitsubishi A/V

receiver, the audio position may be used in conjunction with selected Mitsubishi CD players. Your audio position must be programmed to 010 ].

If the remote control has not been programmed to operate NetCommand™ and slide switch is set to TV when you enter an A/V receiver code, VOLUME and MUTE will control the A/V receiver rather than the TV. To return volume and mute control to the TV, set the slide switch to TV, press and hold POWER and enter 000.

Some manufacturers may change their products, or they may use more than one remote control system. If this is the case, your remote control may not be able to operate your VCR, DVD, cable box, satellite receiver, or A/V receiver.

68