40 Chapter 3 Using your Tablet PC
For each battery, you can check the remaining battery power from the battery itself.
To check the battery status using the gauge on the battery
•Locate the battery gauge button and the battery power indicator lights and press the
battery gauge button. The indicator lights show the remaining charge. Each light
represents approximately 20% of the available charge.
•A Battery fault code is indicated when you push the battery gauge button and the top,
middle, and bottom lights on the battery illuminate simultaneously. If this occurs, the
battery has failed and must be replaced.
Charging the battery
When the TabletPC is connected to AC power, the battery automatically charges until it
reaches full charge, even if the TabletPC is being used The battery status light on the Tablet
PC will blink amber when the battery is installed and AC power is applied to the tablet.
If two batteries are installed, the battery that the tablet is using charges first, then the
second battery charges. The charging sequence is staggered to ensure that both batteries
are being fully charged at nearly the same time. The first battery (with lowest remaining
power) charges to the 90% level, followed by the second battery charging to the 100% level.
Then, the tablet switches to the first running battery.
For information about the battery status light, see “Battery status light” on page 12.
CAUTION: To avoid injury, keep the battery within the recommended temperature range
while it is charging. If the battery has been subjected to a hot environment, wait until it
Battery gauge button
.
Battery power indicator lights