Table A-1.

AT Commands, Cross-Referenced to Front Panel Options (Continued)

AT

 

Parameter &

 

Command

Option

Description

 

 

 

AT*ZP2

=Ack Only

After validating the password, the modem generates an acknowledgment tone before hanging

 

 

 

up. This indicates to the caller that the access security password is valid and that the modem

 

 

 

should expect to receive a callback. Upon hearing the tone, the caller should hang up

 

 

 

immediately. This setting is intended for callback only.

AT

ZP3

=Prompt/Ack

Upon answering a call, the local modem generates both the prompt and acknowledgment tone

*

 

 

at the appropriate times. This setting is intended for manual dialing only.

 

 

 

NOTE: For a detailed description of how the modem’s access security and call features

 

 

 

operate, refer to Chapter 2 of the 326X Series Modem Reference Guide.

 

 

 

 

 

Rem Num Rqrd Remote Number Required

 

 

 

Specifies whether a remote callback number is required when using AT*ZC (Callback).

 

 

 

NOTE: For a detailed description of how the modem’s access security and call features

 

 

 

operate, refer to Chapter 2 of the 326X Series Modem Reference Guide.

AT

ZR0

=Off

A remote callback number is not required. If the calling modem does not provide a callback

*

 

 

number, the modem attempts to establish a connection without hanging up or calling back.

AT

ZR1

=On

A remote callback number is required. The modem does not attempt to make a connection or

*

 

 

callback if no callback number is provided.

 

 

Sim Ring

Simulated Ringback

 

 

 

Determines whether the answer modem sends a ringback tone to the calling modem prior to

 

 

 

sending an answer-back tone immediately after entering the access security password.

 

 

 

NOTE: For a detailed description of how the modem’s access security and call features

 

 

 

operate, refer to Chapter 2 of the 326X Series Modem Reference Guide.

AT*ZS0

=Disable

No ringback tone is sent to the remote modem prior to sending an answer-back tone.

AT

ZS1

=Enable

After receiving the access security password, the answer modem sends a ringback tone to the

*

 

 

remote modem (prior to sending an answer-back tone).

 

 

PW Verify

Password Verification

 

 

 

This command determines whether the access security feature is enabled. If access security is

 

 

 

enabled, this option selects the method used to verify a password.

 

 

 

NOTE: For a detailed description of how the modem’s access security and call features

 

 

 

operate, refer to Chapter 2 of the 326X Series Modem Reference Guide.

AT*ZV0

=Dis

Password and callback features are disabled.

AT*ZV1

=Intern

A single password, stored in modem memory, is checked against the received password. This

 

 

 

password is stored in modem memory using the AT*ZI (Enter Group PW?) command.

Only

 

Mngr

The network management system verifies the received password. Although displayed at the

accessible

 

modem, this selection is not accessible by the front panel or AT ACU.

with an NMS

 

 

 

 

 

 

Gray shading indicates country-specific options. See Appendix C for your country’s options.

Configuration

Quick-Reference

Configuration Quick Reference A-33

Page 155
Image 155
Motorola 326X V.34 Rem Num Rqrd Remote Number Required, Sim Ring, Simulated Ringback, PW Verify, Password Verification