Motorola 326X V.34, and V.32bis manual Group PW, OverrideMode, NC Address, NC PortRate, Pass Thru

Configuration Quick-Reference

Table A-2.

Front Panel Configuration Options (Continued)

	Parameter &
326X Menu	Option	Description
ACCESS	Group PW	Determines if the modem can verify a received password when PW Verify=Mngr (AT*ZV) and
SECURITY		the network management system is unable to perform the verification. This option is not accessi-
		ble from the front panel or the AT ACU. It is displayed for status purposes only.
	=Disable	The modem cannot verify the password.
	:Enable	The modem can verify the password using its Group PW stored internally.
NETWK	OverrideMode	Determines whether your modem can be controlled by the network manager.
CNTL OPT’S
	=Off	The network manager can attach your modem. When it has attached, front panel control is
		locked out. You can display options and status in the front panel menu tree, but you cannot
		change options. If you attempt to change a setting, the modem displays Net Man Attached.
	:On	The network manager cannot attach your modem.
	NC Address	Lets you set the modem’s network control address. This is the address that modems use with the
		SET RMT LL ADDR and SRCH RMT LL ADDR functions. The range of addresses is 0 to 254.
		To set a network control address, see “Performing Numeric Entry” in this appendix.
	NC PortRate	Set the NC Port Rate option to match the speed of your network manager. This option controls
		the speed of the NC ports on your modem’s rear panel.
	= 75	Configures the network control port for speeds indicated in bits per second (bps).
	: 110
	: 150
	:1200
	:2400
	:4800
	:9600
	Pass Thru	The modem uses an in-band secondary channel to pass network management data to the remote
		modem. The channel is not disruptive to main channel user data. Pass Thru controls how
		network control data is passed to the remote modem when the modem is configured as DIAL.
	=opt 1	The local modem (connected to a network manager through the NC port) does not forward all
		network management data received from the NC port to the remote modem over the in-band sec-
		ondary channel. Only commands from the network manager to the remote modem are passed
		through. Only remote-modem responses are passed to the network manager.
	=opt 2	The modems do no filtering. They pass all network management data received from the NC port
		to the in-band secondary channel and from the in-band secondary channel to the NC port.
SET RMT LL	New Address=nnn	The SET RMT LL ADDR menu is for use with remote configuration on leased lines. Using this
ADDR	Rmt Ser#=	option, you can set the remote modem’s address.
	nnnnnnn
	Rmt Nest
	Modem=No, A, B.
SRCH RMT	Rmt	The SRCH RMT LL ADDR menu is for use with remote configuration on leased lines. Using
LL ADDR	Ser#=nnnnnnn	this option, you can search for the remote modem’s address.
	Rmt Nest
	Modem=No, A, B.

Gray shading indicates country-specific options. See Appendix C for your country’s options.

A-36 Configuration Quick Reference