Motorola 326X V.34, and V.32bis, V.34-SDC manual Additional Equipment Required, Choosing a Site

Additional Equipment Required

Installing the Modem

Modem-to-Terminal Cable

Personal Computer with Communications	Asynchronous or Synchronous
Software Package	Terminal (DTE)

In addition to the items supplied with the modem, you may need the following:

	•	Communications Software Package
		Many modem applications are controlled by communications software that
		supports serial communications. When connecting a modem to a terminal,
		communications software is unnecessary. (Refer to Chapter 3 and Chapter 4 for
		more information.)
	•	Serial Cable
		A shielded, straight-through modem-to-terminal cable, data communications
		equipment (DCE) to data terminal equipment (DTE) cable, is required.
		The cable must have a 25-pin D male connector and a DTE connector.
		For modem-to-modem (or other DCE-DCE connection), use a crossover cable.
		The cable must support the modem signaling your application requires. Select a
		cable based on your computer and the DTE pin assignments in Appendix B.
Appendix B

Choosing a Site

Where you place the modem can affect its operation. To enhance performance:

•Install the modem in a clean, well-lighted area that is free from temperature extremes and dust.

•Do not place anything on top of a modem.

•Locate the modem no more than the EIA-recommended distance from a DTE and within 6 feet (1.83m) of a grounded AC power outlet.

•Do not place anything within 1 inch (2.54 cm) of either side of a modem. Also, to prevent overheating, do not place a modem on its side.

Refer to Appendix C for site requirements for operating the modem in your country.

Appendix C

2-4 Installing the Modem