2.Lay out the
3.Connect the ground cord assembly to the ESD mat and to the ground plug on the front fan tray. This takes a standard banana jack or a
4.Wear the ESD wrist strap and attach it to the ground cord assembly.
Installing the Mounting Shelf
*Note: The screws and nuts needed to attach the shelf to the rack are not supplied. It is recommended you use, at least, a quantity of three #10 pan head screws for installation.
There are three brackets supplied for the shelf installation: shelf pieces and one brace for the rear of the rack. To install the shelf:
1.Install the mounting shelf. Attach the two side shelf pieces to the rack. Make sure that each hole on the mounting bracket lines up with a hole on the rail. This ensures proper vertical placement in the rack. Do not completely tighten the screws.
2.Attach the brace piece to the shelf pieces by inserting the attached stud into the holes on the shelf pieces and tightening the nuts (Figure 2).
3.Check the rack and shelf to ensure they are square before installing the chassis. Tighten all screws before installing the chassis.
Figure 2. Installing the Mounting Shelf
Cajun P880 Routing Switch Installation Guide | 1 - 5 |
