Motorola P880 manual Parameter Definition, Disable DTR

2

To configure the console serial port as a PPP console:

1.In the System Configuration section of the Web Agent window, select Console Configuration. The Console Configuration dialog box opens.

2.Click PPP for your console type and click Select. The Console Port Configuration dialog box opens.

3.Use Table22 to change your console port settings.

*Note: The only parameters you can change as a PPP console is baud rate and flow control. The flow control settings are limited to None or Xon/Xoff.

4.In the Modem Init Cmd field, enter your modem initialization command. The default modem configuration string is AT&D0S0=1.

Table 23. Modem Configuration String Parameters

Parameter	Definition
&D0	Disable DTR
S0=1	Auto-answer mode (one ring)
CD follows carrier	Depends on modem
E0	Disable local echo
Software Flow Control	Depends on modem
(Receive and Transmit)

5.Click APPLY to save your changes, or CANCEL to restore previous settings.

*Note: If you misconfigure your PPP serial console port, you can regain CLI access to correct the configuration parameters. For more information, refer to “Regaining Configuration Access to the PPP Serial Port Console”.

Safety Tip: To successfully dial-in with PPP to the switch, you must also configure an IP address and interface for the PPP Serial Interface (Serial-Console).

2 - 32 Cajun P880 Routing Switch Installation Guide