Display

Meaning

Suggested solutions

 

 

 

 

 

Load Document

You have attempted to set up a

Load a document and try again.

 

 

copy or fax operation with no

 

 

 

document loaded.

 

 

 

 

 

 

[Low Heat

There is a problem in the fuser

Unplug the power cord and plug it back

 

Error]

unit.

in. If the problem persists, please

 

 

 

contact a service representative.

 

Open Heat Error

 

 

 

 

 

 

 

 

 

[Over Heat]

 

 

 

 

 

 

 

[LSU Error]

A problem has occurred in the

Unplug the power cord and plug it

 

 

LSU (Laser Scanning Unit).

back in. If the problem persists,

 

 

 

please call for service.

 

 

 

 

 

Memory Full

The memory is full.

Delete unnecessary documents,

 

 

 

retransmit after more memory

 

 

 

becomes available or split the

 

 

 

transmission into more than one

 

 

 

operation.

 

 

 

 

 

[No Answer]

The remote fax machine has

Try again. Make sure that the remote

 

 

not answered after several

machine is operational.

 

 

redial attempts.

 

 

 

 

 

 

NO. Not

The One-touch or speed dial

Dial the number manually using the

 

Assigned

location you tried to use has

number keypad or assign the number.

 

 

no number assigned to it.

For storing a number, see page 2.16.

 

 

 

 

 

[No Paper]

The paper tray has run out of

Load paper in the paper tray. See

 

Add Paper

paper.

page 1.9.

 

 

 

 

 

Operation Not

You are doing in the Add/

Check the display to see if there is any

 

Assigned

Cancel operation, but there is

scheduled job. The display should

 

 

no jobs waiting.

indicate them in Standby mode, for

 

 

 

example, Delay Fax.

 

 

 

 

 

[Paper Jam 0]

Paper has jammed in the

Clear the jam. See page 6.3.

 

Open/Close Door

feeding area of the paper tray.

 

 

 

 

 

 

[Paper Jam 1]

• Paper has jammed in the

• Clear the jam. See page 6.4.

 

Open/Close Door

 

 

paper exit area.

 

 

 

• Clear the jam. See page 6.5.

 

 

• A paper jam has occurred in

 

 

 

6

 

the manual feeder or the

 

 

machine detects non-feeding

 

 

from the manual feeder.

 

 

 

 

 

 

[Paper Jam 2]

Paper has jammed in the fuser

Clear the jam. See page 6.4.

 

Check Inside

area.

 

 

 

 

 

 

Power Failure

Power has turned off then on

You need to start again the job which

 

 

and the machine’s memory

you were trying to do before the

 

 

has not been saved.

power failure.

 

 

 

 

 

Retry Redial?

The machine is waiting for a

You can press Enter to immediately

 

 

specified time interval to redial

redial, or Stop/Clear to cancel the

 

 

a previously busy station.

redial operation.

 

 

 

 

 

TROUBLESHOOTING 6.7

Page 81
Image 81
Muratec F-112 One-touch or speed dial Dial the number manually using, Location you tried to use has, Paper, Area