3Disassemble the white roller as follows:

The right end of the white roller has a plastic bushing that is snapped shut with small tab on it. Pull the bushing slightly inward, then rotate the bushing until it reach a slot (1). Then pull the roller upward (2).

4Wipe the roller surface with a soft cloth dampened with water.

5Carefully wipe the scanning glass with a soft dry cloth.

If the glass is very dirty, first wipe it with a slightly dampened cloth, and then with a dry cloth. Be very careful not to scratch the glass surface.

5

6Replace the roller by inserting the left end first followed by the right end, then rotating the bushing until it locks into place.

7Reconnect the support and the control panel, then close the control panel firmly until it clicks into place.

MAINTENANCE 5.5

Page 69
Image 69
Muratec F-112 user manual Disassemble the white roller as follows