Muratec F-98 operating instructions An introduction to Review Commands, Set # Of Redials # 02-15

Getting started

Making redial settings

It’s up to you how many times the fax redials a number and how long it waits between redials (that length of time between calls is the redial interval). Here’s how to program the redial settings:

1 Press PROGRAM, J, 0, 7, ENTER.

Set # Of Redials

#(02-15): 02

If the number of redialings you see is acceptable, skip to step 3.

Otherwise, proceed to step 2.

2 To change the setting, use the numeric keypad to enter the desired number of redialings, as few as two or as many as 15. In this example, we’ve entered 03, for three.

Set # Of Redials

#(02-15): 03

Important: Notice that you must enter a leading zero when setting a quan- tity lower than 10.

3 Press ENTER to save the setting.

4 The LCD now shows:

Set Redial Interval

Inter. (3-5): 3

If the redial interval (in minutes) you see is acceptable, skip to step 6. Otherwise, proceed to step 5.

5 To change the setting, use the numeric keypad to enter the desired length (in minutes). You may enter 3, 4 or 5. In this example, we’ve chosen 4.

Set Redial Interval

Inter. (3-5): 4

6 Press ENTER to save the setting.

An introduction to Review Commands

To cancel either a transmission in progress, an automatic redial or a delayed com- mand, you’ll use the Review Commands function. First, a short explanation . . .

•Because your fax machine can store multiple commands in memory, it keeps track of each command by assigning it a command number, like “C01.”

•Delayed commands, redial attempts and current fax transmissions are all stored in your fax machine’s memory and given a command number.

The Review Commands function gives you the power not only to check on (review) each command currently in your machine’s memory but also to delete a command if you decide not to send the document.

Note: Press STOP to cancel a transmission in progress when you are transmitting from the document feeder. (You cannot use the REVIEW COMMANDS key.)

1 Press REVIEW COMMANDS.

The LCD shows the first command, indicated by its command number and the phone number the command will dial. If a command is in progress, that will be the first command the LCD shows:

C01:5552009

Program/Cancel

2 If this is the command you want to cancel, skip to step 4.

If this is not the command you want to cancel, proceed to step 3.

3 Press PROGRAM to continue on to the next command in the command queue, then go back to step 2.

4 Press CANCEL. The LCD shows:

C01:5552009

Check Program/Cancel

5 If you do want to cancel this command, press CANCEL again.

6 The LCD now shows the next command.

If you want to cancel it, too, go back to step 4.

If you want to avoid cancelling this command but do want to review other commands in the queue, press PROGRAM and go back to step 2.

If you want to stop reviewing the stored commands, press STOP to return the machine to standby mode.

This function gives you enormous control over your machine’s most powerful features. For more information on the Review Commands function, please see page 2.20.

1.16