Muratec F-98 Programmable one-touch fax dialing, Erasing a programmable one-touch key

Programmable one-touch fax dialing

To dial a fax call using a programmable one-touch number: 1 Insert the document.

2 Adjust the resolution and contrast if necessary.

3 Toggle between transmission from the feeder or from memory if necessary, by

pressing MEMORY TRANSMIT.

4 Press the programmable one-touch key in which you’ve stored the number.

Your fax will perform the operation either now or at whatever time you set.

Note: To review each available operation’s details, please review its appropriate instructions. See page 2.34 for a list of where you may find each operation.

If you programmed this key to delay its operation, the LCD will show:

** Reserved **

A4 Memory 95%

If you programmed this key to perform the operation immediately after the key- press, the LCD will show the number:

9-1-972-555-4335

A4 Normal

Erasing a programmable one-touch key

1 Press PROGRAM, C, 2, ENTER. The LCD shows something like:

Select Program No.

P1:Delayed

If P1 is the key you want to erase, skip to step 3. (However, our examples from here will say “P3” rather than “P1.”)

2 Press the programmable one-touch key you want to erase. Here, we’ve selected P3:

Select Program No.

P3:Polling

3 If you change your mind and want to erase a different programmable one- touch key, just press that key before going on step 4.

Beyond the basics

4 Press ENTER. The LCD shows:

Erase P One-Touch

Check Program/Enter

Important: If you want to quit without erasing the programmable one- touch key you’ve selected, press PROGRAM. The fax will return to step 2.

5 Press ENTER to erase the number.

Erase P One-Touch ** Complete **

To erase another programmable one-touch key, repeat steps 2–5. Or press STOP to return to standby mode.

Printing a list of your programmable one-touch keys

You fax machine can print a list of the commands you’ve stored in your programma- ble one-touch keys. The list includes each key’s one-touch letter, the telephone number, when the command should start, which command you’ve selected and — if applicable — the selected call group(s) for the broadcast initiation you’ve stored in the key.

To print the list, press PROGRAM, C, 3, ENTER.

2.41