Chapter 6 Performing Sweep Measurements
Getting Started with LabVIEW SignalExpress 6-4 ni.com
Plotting Sweep Results
Complete the following steps to run the sweep measurement.
1. Click the Run Once button, shown at left, to execute the sweep
measurement.
The stimulus signal output on the graph iterates through the specified
range of frequencies.
2. Drag the response amplitude in dB vs. Frequency signal from the
bottom of the Sweep loop to the Data View to display the output of the
sweep.
LabVIEW SignalExpress creates a new graph. The data from a sweep
operation is an x-y array that requires a separate graph, as shown in
Figure 6-3.
Figure 6-3. Sweep.seproj