User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software

Format

config radius accounting mode <enable/disable>

config radius accounting server add

This command configures the IP address to use for the accounting server. Only a single accounting server can be configured. If an accounting server is currently configured it must be removed using the ‘config radius accounting server remove’ command before the add command will succeed.

Format

config radius accounting server add <ipaddr>

config radius accounting server port

This command configures the UDP port to use for the accounting server. The IP address specified must match that of the previously configured accounting server. If a port is already configured for the accounting server, the new port will replace the previously configured value. The port must be a value in the range of 0 and 65535.

Default

1813

Format

config radius accounting server port <ipaddr> <0-65535>

config radius accounting server remove

This command removes a configured accounting server. The IP address specified must match that of the previously configured accounting server. Since only a single accounting server is supported, issuing this command will cause future accounting attempts to fail.

Format

config radius accounting server remove <ipaddr>

config radius accounting server secret

This command configures the shared secret between the RADIUS client and the RADIUS accounting server. The IP address specified must match that of the previously configured accounting server. When this command is issued, the secret will be prompted. The secret must be an alphanumeric value of 20 characters or less.

Format

config radius accounting server secret <ipaddr>

7-60

Switching Commands

202-10010-01

Page 102
Image 102
NETGEAR 7200 Series user manual Config radius accounting server add, Config radius accounting server port