User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software

show snmpcommunity

This command displays SNMP community information.

Six communities are supported. You can add, change, or delete communities. The switch does not have to be reset for changes to take effect.

The SNMP agent of the switch complies with SNMP Version 1 (for more about the SNMP specification, see the SNMP RFCs). The SNMP agent sends traps through TCP/IP to an external SNMP manager based on the SNMP configuration (the trap receiver and other SNMP community parameters).

Format

show snmpcommunity

SNMP Community Name

The community string to which this entry grants access. A valid entry is a case-

 

sensitive alphanumeric string of up to 16 characters. Each row of this table must

 

contain a unique community name.

Client IP Address

An IP address (or portion thereof) from which this device will accept SNMP

 

packets with the associated community. The requesting entity's IP address is

 

ANDed with the Subnet Mask before being compared to the IP Address. Note:

 

that if the Subnet Mask is set to 0.0.0.0, an IP Address of 0.0.0.0 matches all IP

 

addresses. The default value is 0.0.0.0

Client IP Mask

A mask to be ANDed with the requesting entity's IP address before comparison

 

with IP Address. If the result matches with IP Address then the address is an

 

authenticated IP address. For example, if the IP Address = 9.47.128.0 and the

 

corresponding Subnet Mask = 255.255.255.0 a range of incoming IP addresses

 

would match, i.e. the incoming IP Address could equal 9.47.128.0 -

 

9.47.128.255. The default value is 0.0.0.0

Access Mode

The access level for this community string. May be specified by selecting Read/

 

Write or Read Only from the pull-down. Updates will be made to the switch by

Status

pressing the Submit button.

The status of this community access entry. When this object is set to enabled, if

 

the Community Name for this row is not unique among all valid rows, the set

 

request will be rejected. Community names may be made invalid by selecting

 

disable. Rows may be deleted by selecting Delete. Updates will be made to the

 

switch by pressing the Submit button.

config snmpcommunity accessmode

This command restricts access to switch information. The access mode can be read-only (also called public) or read/write (also called private).

Format

config snmpcommunity accessmode <rorw> <name>

Switching Commands

7-17

202-10010-01

Page 59
Image 59
NETGEAR 7200 Series user manual Show snmpcommunity, Config snmpcommunity accessmode rorw name