User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software

config garp gvrp adminmode

This command enables or disables GVRP.

Default

disable

Format

config garp gvrp adminmode <enabledisable>

config garp gvrp interface mode

This command enables or disables GVRP (GARP VLAN Registration Protocol) for a specific port. If GVRP is disabled, Join Time, Leave Time and Leave All Time have no effect.

Default

disable

Format

config garp gvrp interface mode <slot.portall>

 

<enabledisable>

config garp jointimer

This command sets the GVRP join time per port and per GARP. Join time is the interval between the transmission of GARP Protocol Data Units (PDUs) registering (or re-registering) membership for a VLAN or multicast group.

This command has an effect only when GVRP is enabled. The time is from 10 to 100 (centiseconds)

Default

20 centiseconds (0.2 seconds)

Format

config garp jointimer <slot.port/all> <10-100>

config garp leavetimer

This command sets the GVRP leave time per port. Leave time is the time to wait after receiving an unregister request for a VLAN or a multicast group before deleting the VLAN entry. This can be considered a buffer time for another station to assert registration for the same attribute in order to maintain uninterrupted service.time is 20 to 600 (centiseconds).

Note: This command has an effect only when GVRP is enabled.

Default

60 centiseconds (0.6 seconds)

Format

config garp leavetimer <slot.port/all> <20-600>

Switching Commands

7-37

202-10010-01

Page 79
Image 79
NETGEAR 7200 Series user manual Config garp gvrp adminmode, Config garp gvrp interface mode, Config garp jointimer