User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software
config snmptrap ipaddr
This command assigns an IP address to a specified community name. The maximum length of name is 16
Note: IP addresses in the SNMP trap receiver table must be unique. If you make multiple entries using the same IP address, the first entry is retained and processed. All duplicate entries are ignored.
Format | config snmptrap ipaddr <ipaddrold> <name> <ipaddrnew> |
config snmptrap mode
This command activates or deactivates an SNMP trap. Enabled trap receivers are active (able to receive traps). Disabled trap receivers are inactive (not able to receive traps).
Format | config snmptrap mode <enabledisable> <name> <ipaddr> |
show trapflags
This command displays trap conditions. Configure which traps the switch should generate by enabling or disabling the trap condition. If a trap condition is enabled and the condition is detected, the switch's SNMP agent sends the trap to all enabled trap receivers. The switch does not have to be reset to implement the changes. Cold and warm start traps are always generated and cannot be disabled.
Format | show trapflags |
Authentication Flag | May be enabled or disabled by selecting the corresponding line on the pull- |
| down entry field. The factory default is enabled. Indicates whether |
| authentication failure traps will be sent. |
Link Up/Down Flag | May be enabled or disabled by selecting the corresponding line on the pull- |
| down entry field. The factory default is enabled. Indicates whether link status |
| traps will be sent. Multiple Users Flag. |
Multiple Users Flag | May be enabled or disabled by selecting the corresponding line on the pull- |
| down entry field. The factory default is enabled. Indicates whether a trap will be |
| sent when the same user ID is logged into the switch more than once at the same |
| time (either via telnet or serial port). |
Spanning Tree Flag | May be enabled or disabled by selecting the corresponding line on the pull- |
| down entry field. The factory default is enabled. Indicates whether spanning tree |
| traps will be sent. |
Broadcast Storm Flag | May be enabled or disabled by selecting the corresponding line on the pull- |
| down entry field. The factory default is enabled. Indicates whether broadcast |
| storm traps will be sent. |
|
|
Switching Commands |
