NETGEAR ProSafe SSL VPN Concentrator 25 SSL312 Reference Manual
Figure
2.Enter the Ethernet Port 1 subnet mask that has been configured for your network. The subnet mask value should be the same value as the subnet mask configured on your network computers. The factory default is 255.255.255.0 (The subnet mask specifies the network number portion of an IP address.).
3.Only if you plan to use two port mode, enable routing mode by checking this checkbox. The second Ethernet port will be enabled.
Note: NETGEAR recommends one port operation for most networks.
4.Enter a local or internal IP address of your ProSafe SSL VPN Concentrator 25. This address should be in a different subnet than the Ethernet Port 1 IP address. The default Ethernet Port 2 IP Address is 10.0.0.1.
Additional System Configuration |
