NETGEAR SSL312 manual Defining and Editing Group Policies

NETGEAR ProSafe SSL VPN Concentrator 25 SSL312 Reference Manual

Figure 4-7

You can set the inactivity timeout at the user, group and global level. Set the timeout as 0 in the user and group configuration to use the global timeout setting. If multiple timeout settings are configured, the user timeout setting will take precedence over the group timeout and the group timeout will take precedence over the global timeout.

The maximum timeout setting is 232 or over 100,000 minutes, although setting the timeout to 0 on the Global Settings page disables the inactivity timeout (if 0 is also configured as the inactivity timeout for the user and group).

Defining and Editing Group Policies

With group access policies, all traffic is allowed by default. You can create additional allow and deny policies by destination address or address range and by service type.

The most specific policy will take precedence over less specific policies. For example, a policy that applies to only one IP address will have priority over a policy that applies to a range of IP

Setting Up User and Group Access Policies 4-9

v2.0, May 2007