ProSafe Dual Band Wireless-N Access Point WNDAP350 Reference Manual

To set up an SNMP management interface:

1.Under the Maintenance tab, select Remote Management, and then select SNMP from the left sidebar. The SNMP screen displays, as shown in Figure 3-1below:

Figure 3-1 Configure SNMP settings

2.Enter the following information in the SNMP fields:

SNMP: Enable SNMP to allow the SNMP network management software, such as HP OpenView, to manage the wireless access point via SNMPv1/v2 protocol.

Read-Only Community Name: The community string to allow the SNMP manager to read the wireless access point's MIB objects. The default is Public.

Read-Write Community Name: The community string to allow the SNMP manager to read and write the wireless access point's MIB objects. The default is Private.

Trap Community Name: The community string to allow the SNMP manager to send traps. The default is trap.

IP address to Receive Traps: The IP address of the SNMP manager to receive traps sent from the wireless access point.

Trap Port: The port number on which the SNMP Manager will receive traps. The default is 162/UDP.

3-2

Management

v1.1, November 2009

Page 68
Image 68
NETGEAR WNDAP350-100NAS manual Configure Snmp settings