ProSafe Dual Band Wireless-N Access Point WNDAP350 Reference Manual

To use the CLI from a Console Port:

1.Using the null-modem cable, connect a VT100/ANSI terminal or a workstation to the port labeled Console.

If you attached a PC, Apple Macintosh, or UNIX workstation, start a secure terminal- emulation program.

2.Configure the terminal-emulation program to use the following settings:

Baud rate: 9600 bps

Data bits: 8

Parity: none

Stop bit: 1

Flow control: none

These settings appear below the connector on the back panel.

3.Press Enter. The screen shown below in Figure 3-3should appear.

Figure 3-3

4.Enter the login name and password (admin and password are the defaults).

After successful login, the <Access Point Name> prompt should appear. In this example, the prompt is netgear74F35E.

5.Enter help to display the CLI command help.

CLI Commands

The CLI commands are listed in Appendix C, “Command Line Reference.”

3-4

Management

v1.1, November 2009

Page 70
Image 70
NETGEAR WNDAP350-100NAS manual CLI Commands