NETGEAR WNDAP350-100NAS manual Field Description Access Point Information, Current IP Settings

ProSafe Dual Band Wireless-N Access Point WNDAP350 Reference Manual

Under the Monitoring tab on the main menu, select System to view the System screen, shown in Figure 3-11below. This screen shows the parameters listed in Table 3-1:

Table 3-1. System Information Fields

Field	Description
Access Point Information
Access Point Name	Indicates the NetBIOS name. The default name may be changed, if desired.
Ethernet MAC Address	Displays the Media Access Control address (MAC address) of the wireless
	access point’s Ethernet port.
Wireless MAC address for	Displays the Media Access Control address (MAC address) of the wireless
2.4GHz	access point’s wireless card when operating at 2.4GHz
Wireless MAC address for	Displays the Media Access Control address (MAC address) of the wireless
5GHz	access point’s wireless card when operating at 5GHz
Country/Region	Displays the domain or region for which the wireless access point is
	licensed for use. It may not be legal to operate this wireless access point in
	a region other than one of those identified in this field.
Firmware Version	The version of the firmware currently installed.
Current Time	Displays the current system time of the access point.
Current IP Settings
IP Address	The IP address of the wireless access point.
Subnet Mask	The subnet mask for IP address of the wireless access point.
Default Gateway	The default gateway for the wireless access point communication.
DHCP Client	Enabled indicates that the current IP address of the AP was obtained from a
	DHCP server on your network. Disabled indicated a static IP configuration.
Current Wireless Settings for 802.11b/bg/ng
Operating Mode	Identifies the 802.11 operating mode of the WNDAP350.
Channel/Frequency	Identifies the channel the wireless port is using. ‘Auto’ is the default channel
	setting. (Channel frequencies used on each channel can be found in “Wire-
	less Communications”; a link to this article is in Appendix B, “Related
	Documents.).
Rogue AP Detection	Identifies whether the Rogue AP detection feature is enabled or disabled.
Current Wireless Settings for 802.11n/na
Operating Mode	Identifies the 802.11 operating mode of the WNDAP350.

Management 3-13

v1.1, November 2009