Off-premise Message Notification 69
P0911621 Issue 02 Enterprise Edge 2.0 Voice Messaging Reference Guide
7. Enter the destination pager number and press OK or
£.
8. Press OK or £ to accept the destination pager number.
The <x> represents the pager number. Press ADD or
¤ to add special characters. If the paging service
requires additional answer or setup time, add pause
characters to the beginning of the pager message. For
information, refer to Adding special characters to the
destination number on page 56. After you add special
characters, press OK or £ to accept the destination
number.
9. Press NEXT or £ to accept the default pager message
(represented by <xxxx>). The default pager message
sent by Enterprise Edge Voice Messaging is the
Enterprise Edge Voice Messaging extension. This is
the sequence of digits that is sent after the pager
service is dialed, to notify you of who is paging you.
Press CHNG or ⁄ to change the pager message.
Note: The combined limit is 30 characters for the
pager phone number and the pager message.
10. You can choose to be notified of all new messages or
urgent messages only. Press OK or £ to accept the
default message type new. This means you are notified
whenever you receive a new message. Press CHNG or
⁄ to change the message type to urgent. Changing
the message type to urgent means you are notified
only when you receive an urgent message.
11. Press ƒ to end the session.
Pager:
RETRY OK
<x>
ADD OK
Show:<xxxx>
CHNG NEXT
Msg type: new
CHNG OK
Msg notify
ADMIN SELECT