2. Installation and connection
2-3 Connecting the equipment
Caution
Do not connect devices with rated voltage of 200 to 240 VAC or higher.
●The rated output voltage of this device is 200 to 240 VAC.
●Overcurrent may damage the connected devices.
When in use, make sure the output terminal block cover is attached. Do not turn ON the power switch when it is detached.
●Voltage is applied to the output terminal block when the power switch is ON, which can result in electric shock.
<Example of connection 1 >
BU1002SW |
PC
To power supply output receptacle
BU3002SW
PC
To power supply output receptacle
<Example of connection 2 >
Connected device (1)
Connected device (2)
To the terminal block for output
Connected device (1)
Connected device (2)
To the terminal block for output
●Group control of power supply output
This function can be used with the UPS monitoring software included with the UPS. The output receptacles of the BU1002SW are separated into 3 groups: A, B, and C.
1.Power supply output group A
Output begins at the same time as startup.
2.Power supply output group B, C
•The output start times for power supply output group B and C are independent of power supply output group A, so they can be delayed or set to precede the output stop time.
•The output start/stop time control funtion is available when using the included “PowerAct Pro” UPS monitoring software, “UPS Power Manager” or “SNMP/Web card”.
•Output ON/OFF can be controlled with the included UPS monitoring software while the BU1002SW is operating.
•The delay settings and ON/OFF control described here can be performed independently for power
supply output group B and power supply output group C.
This function can be used to set the startup order of servers, peripheral devices, etc. The output receptacles can also be forcibly turned ON/OFF remotely.
24
