Panasonic KX WP1050 operating instructions Registering the handset

Handset Locator and Registration

Registering the handset

The handset and the base unit are preregistered. If for some reason the handset is not registered to the base unit, after you change the base unit’s wireless settings (page 168), or after you reset all the handset settings (page 123), register the handset. The handset and the base unit need to be closely located during the registration.

1

2

3

4

5

LOCATOR indicator LOCATOR button

{Menu} (middle soft key)

“Settings” i{Select}

“Phone settings” i{Select}

“Registration” i{Select}

“HS registration” i{Select}

6 Press and hold the LOCATOR button on the base unit for 4 seconds until you see the LOCATOR Indicator on the base unit flashing in green. i{OK}

L The registration starts. The status message changes from “Handset registering” to “Handset registered”.

Note:

L In step 5, select “Information” to view the network name and BSSID (the MAC address) information for the base unit. i{Select}

L When the handset registration fails, the status message “Handset could not register. Please try again.” is displayed. Press {OK}. Try step 6 again.

L You can register only 1 handset to the base unit. Therefore, if you register another handset to the base unit, the previously registered handset cannot be connected to the base unit.

L While the handset is being registered, the LOCATOR indicator on the base unit flashes.

For assistance, please visit http://www.panasonic.com/help 133