Base Unit Settings

3 Configure the settings, then click [Save].

 

 

 

 

Setting

Description

 

[Transmission/

L Select whether to deny or allow packets to be sent or

 

reception of

received when the source of an incoming (from WAN) packet

 

Packets with

and the destination of an outgoing (to WAN) packet are

 

private IP

private IP addresses. This feature is valid when the WAN IP

 

addresses via

address is global. The default is set to Deny.

 

WAN interface]

L Check whether output or not this log. The default is set to ON.

 

[Stateful Packet

L Select whether to enable or disable the stateful packet

 

Inspection]

inspection feature.

 

 

L Some E-mail servers authenticate clients using identification

 

 

packets which use TCP port 113. If the E-mail feature does

 

 

not work well, select [Enable (Except Ident Packets)],

 

 

which is the default setting for this feature.

 

 

L Check whether output or not this log. The default is set to ON.

 

[Attack Detection]

L Select whether to enable or disable the attack detection

 

 

feature. The default is set to Disable.

 

 

L The following type of attacks can be detected:

 

 

– TCP Scan

 

 

– UDP Scan

 

 

– ICMP Echo

 

 

L Check whether output or not this log. The default is set to

 

 

OFF.

L Check the box in the Log Output column to create a log of each action.

L If you select [Enable] and check “Log Output”, the log will be output. If you select [Disable], the log will not be output even if you check “Log Output”.

4 Click [Restart].

L The base unit automatically restarts and the Top Menu is displayed.

Note:

L This feature is not available in AP (Bridge) mode.

For assistance, please visit http://www.panasonic.com/help

161

Page 161
Image 161
Panasonic KX WP1050 Setting Description Transmission, Reception, Packets with, Private IP, Addresses via, WAN interface