Base Unit Settings
For assistance, please visit http://www.panasonic.com/help 209
Note:
LIn step 5, enter the handset’s IP address into the “Do not use proxy server for addresses
beginning with:” data field when you update the firmware of the handset.

Setting UPnP to display the shortcut

To display the KX-WPA102 shortcut in the My Network Places folder, Windows
components should be added. Enable UPnP (Universal Plug and Play) following the steps
below.
1Click [Start], then click [Control Panel].
2Click [Add or Remove Programs], then click [Add/Remove Windows
Components].
3Select [Networking Services], then click [Details…].
4Check [Universal Plug and Play], then click [OK].
5Click [Next>].
Note:
LIf you are using Windows XP Service Pack 2, check [Internet Gateway Device
Discovery and Control Client] and [UPnP User Interface] in step 4.
LThis feature is only available when using Windows XP.

Using your computer on a wireless LAN

The 15 character device-specific network name (SSID) and 13 alphanumeric character
128 bit encryption network key (WEP) are set as factory defaults. These factory default
setting values are shown on the included Wireless LAN sticker. If you use your computer
on a wireless LAN, use the values on the sticker to set the wireless LAN configuration on
your computer. To set your computer to be used on a wireless LAN, see the manual for the
computer you use.
Note:
LTo use your computer on a wireless LAN, a wireless LAN card needs to be installed on
your computer.
WP1050.book Page 209 Wednesday, November 22, 2006 9:24 AM