Chapter 4  Settings — [NETWORK] menu

7)When the confirmation is displayed, select [OK] or [CANCEL], and press the <ENTER> button. Note

ff Not compatible with 10BaseT Full/Half.

When the projector is connected directly via a twisted-pair-cable transmitter

1)Press as to select [DIGITAL LINK SETUP].

2)Press the <ENTER> button.

ff The [DIGITAL LINK SETUP] screen is displayed.

3)Press as to select [DUPLEX(DIGITAL LINK)].

4)Press qw to switch the communication method.

ff The items will switch each time you press the button.

[100BaseTX-Full]

Full duplex communication method is set.

[100BaseTX-Half]

Half-duplex communication method is set.

[AUTONEGOTIATION]

The communication method is set automatically.

5)Press as to select [STORE].

6)Press the <ENTER> button.

7)When the confirmation is displayed, select [OK] or [CANCEL], and press the <ENTER> button.

[DIGITAL LINK STATUS]

Display DIGITAL LINK connection environment.

1)Press as to select [DIGITAL LINK STATUS].

2)Press the <ENTER> button.

ff The [DIGITAL LINK STATUS] screen is displayed.

[LINK STATUS]

Display [NO LINK], [DIGITAL LINK], or [ETHERNET].

[HDMI STATUS]

Display any one of [NO HDMI], [HDMI ON], or [HDCP ON].

 

[SIGNAL QUALITY] is a numerical value of the amount of error, and the display color changes to

 

green, yellow, or red depending on the value.

 

Check the signal quality level while receiving a signal from the twisted-pair-cable transmitter.

 

ff MAX/MIN: Maximum/minimum value of the amount of error.

[SIGNAL QUALITY]

ff Green (-12 dB or lower) → Normal signal quality level.

 

ff Yellow (-11 to -8 dB) → Warning level where there is the possibility of noise introduced on the

 

screen.

 

ff Red (-7 dB or higher) → Abnormal level where synchronization may interrupted, or a signal may

 

not be received.

ENGLISH - 89