Panasonic WV-NM100 Precautions, Do not aim the camera at bright light sources

PRECAUTIONS

●Refer all work related to the installation of this product to qualified service personnel or system installers.

●Do not operate the appliance beyond its specified temperature, humidity, or power source ratings.

Use the appliance at temperatures within 0 °C - + 40 °C (32 °F - 104 °F) and humidity below 90 %. The input power source for this appliance is 120 V AC 60 Hz.

●Handle the appliance with care.

Do not strike or shake, as this may damage the appliance.

●Do not aim the camera at bright light sources.

If a bright light, such as a spotlight, is present on the monitor screen, blooming (blurring around areas with excessive brightness) or smearing (appearance of vertical lines above and below a bright object) may occur.

●Only use the camera indoors.

Do not install it in places where the camera is exposed to sunlight for long periods of time or near air conditioning equipment. This will cause defor- mation, discoloration, breakdown or malfunction.

●Only use the AC adapter provided with this camera to connect to the power source.

Do not plug it into an outlet also hosting big appli- ances with high power consumption (such as a copy machine or an air conditioning unit).

●Do not touch the dome cover directly.

Dirt on the dome cover may decrease the quality of the picture.

Hold it by its sides when you move the camera.

●Do not strike or give a strong shock to the camera.

It may cause damage or allow water to enter the camera.

●Built-in backup battery

Before the first use, charge the built-in backup bat- tery by turning on the power for 48 hours or more. If it is not charged enough, in the case where the power goes down, the internal clock may keep bad time or the operative condition may be different to that before the electric power failure.

The built-in battery life is approximately 5 years. Ask the shop where you purchased the camera when replacement of the battery is required.

●Cleaning

Turn the power off when cleaning the camera. Otherwise it may cause injuries.

●Do not use strong or abrasive detergents when cleaning the appliance body.

Use a dry cloth to clean the appliance when it is dirty.

When the dirt is hard to remove, use a mild deter- gent and wipe gently.

●To obtain clear images

Clean the dome cover approximately once a month to obtain clear images.

●PC monitor

Displaying the same image for a long time on the monitor screen may damage the monitor screen. It is recommended that a screen saver be used.

●Broadband Router

If the camera is connected via the Internet with a router, use a broadband router with address trans- lation (NAT or IP masquerade). Refer to the oper- ating instructions of the broadband router for the description of the address translation.

●Restart automatically when an error is detected.

The camera restarts automatically when an error is detected for any reason. You cannot operate the camera for approximately two minutes after the restart until the initialization has been completed, as happens when the power is turned on for the first time.

●We recommend that you note down your settings and save them. Power or battery failure may erase the settings you entered.

7