Panasonic WV-NM100 Mail notice, Smtp server address, User name, Sender mail address, Pre-alarm

Items on the "Alarm" page

[E-mail notice setup]

"E-mail notice"

Select "ON" or "OFF" to set whether to notice by e-mail or not when an alarm occurs.

"SMTP server address"

Enter the SMTP server address of the sender "Authentication"

Select "SMTP", "POP3" or "None" for the authentica- tion.

"SMTP": Authentication by the SMTP server

"POP3": Authentication by POP before SMTP

"None": No authentication "POP3 server address"

Enter the POP3 server address when "POP3" is selected for "Authentication".

"User name"

Enter the name of the sender, up to 64 characters. "Password"

Enter a password of the sender mail address, up to 64 characters.

"Sender mail address"

Enter the sender mail address. "Attach image"

Select "ON" or "OFF" to set whether to attach an image or not when sending an e-mail. (Only still picture can be attached.)

"Destination E-mail address"

Enter the e-mail address of the recipient. Up to four recipients can be registered.

"Delete destination E-mail address"

Click the [o] button to check the registered e-mail address of the recipient.

You can delete the selected e-mail address of the recipient by clicking the [DEL] button.

[Alarm setup]

"External alarm input"

Select "ON" or "OFF" to set whether to receive alarm input signals or not. For further information, refer to page 53.

[Alarm common setup]

"Pre-alarm"

"Number of image": Set the number of images to store in pre-alarm. You can select a number between 0 and 20.

"Post-alarm"

"Number of image": Set the number of images to store in post-alarm. You can select a number between 0 and 20.

"Interval": Select a frame rate for the image to store among the following:

1/10, 1/5, 1/3, 1/2, 1, 2, 3, 5, 10 (sec)

[External alarm output]

"Alarm type"

Select "Latch" or "Pulse" for the alarm output mode. "Pulse width"

Set the pulse width for the alarm output. "Latch reset"

When resetting of the alarm output latching is required, click the [Reset] button.

[Video Motion Detection (VMD)]

"VMD"

Select "ON" or "OFF" to activate the motion detector function.

"VMD sensitivity"

Select a sensitivity level for the motion detector among the following:

High / Middle / Low

[Panasonic Protocol]

This function is not available yet, however it will be supported in future.

“Panasonic Protocol”

Currently not available. Do not change the default set- ting (OFF).

“Destination port”

Currently not available. Do not change the default set- ting.

“Retry number of times”

Currently not available. Do not change the default set- ting.

“Destination IP address”

Currently not available. Do not change the default set- ting.

“Delete destination IP address”

Currently not available. Do not change the default set- ting.

!Important

•Up to 60 pictures can be saved. The older pictures will automatically be deleted if the number of the pictures exceeds 60 pictures.

•If “1/10” or “1/5” is selected for “Interval” of “Post- alarm”, the interval to store the image may be

longer than the setting.

45